I settled with these adjusters for the rear wheel
The contents of this blog is a record of work carried out by the author and other third party information and pictures gleaned from various sources on the internet. It is published for academic interest and entertainment only. It is neither suggested or intended that any work or modifications shown here are to be carried out by any party reading the blog.
The bike kinda builds itself, all I do is put it together. DISCLAIMER
I have heard so many horror stories about the Indian made Bullet from people who's mate used to have one, that I have lost count. All I can say is that I have covered over 20,000 miles on mine in the last three and a half years, and feel happy that it is quite capable of doing another 20.
So if you like the idea or just curious, you are welcome to come along for the ride.
Monday, 31 October 2011
Sunday, 30 October 2011
Friday, 28 October 2011
Thursday, 27 October 2011
Just need to pull the engine out again and turn the frame upside down to finish the welding off,fit the number plate a dry build then thats about it i think.
Tuesday, 25 October 2011
Had a bit of a stock take tonight and there does not seem to be much left to do
Monday, 24 October 2011
Sunday, 23 October 2011
while i was at work this morning doing the brake i decided to make a few bling bits to tidy her up.
A bracket to feed the cable to the lever.
Saturday, 22 October 2011
Friday, 21 October 2011
Made the first number plate holder,this one is for a vertical plate and i will make a horizontal one try them both and see what i like the best
Thursday, 20 October 2011
The bar in the top of the pik is my lock bar,i like the look of this this very light bobber look.
I am going to put the brake drum lever on top like the old british bike look.
The bar on the bottom pik is how i am going to get it across the frame and the lever is connected to the rear arm,This is going to bolt to the frame as i am going to weld the foot lever and the brake lever in place for safety,plus it a nightmare machining splines
Better work and look clean after all this